Sunday, 4 December 2016

Finishing off Cord Ends of a Drawstring Bag



How do you finish the cord ends of your drawstring bag? Just tie a knot or put a cord-stop on them? Here is a simple method that I had tried out for my stripped drawstring bag. I made a fabric flower bud for each knotted end of the cord.


Materials:
1. Your ready-made drawstring bag with knotted cord ends
2. Two pieces of  8cm x 8cm fabric (different colors)




How to Finish the Ends of the Cord of a Drawstring Bag


Step 1 : Place the two squares right side together and sew around the square completely with a 0.7cm seam allowance. Then, cut a slit or a small hole at the center of the back layer as shown in the picture.




Step 2 : Turn the shape right side out through the hole. You can use point turner to get your corners sharp if you want. Anyway, I didn't use the tool because sharp corners are not very important for this finishing work.




Step 3 : Place the knotted end at the center of the front layer of the square and wrap the knot completely so a "ball"  is created.




Step 4 : Hold the lower part of the ball. Insert the threaded needle through the "ball" and wrap the thread around the lower part of the ball for a few times. Insert the needle through the "ball" again and secure the stitch.




Step 5 : Don't cut the thread, bring the thread through one of the corners and sew together with the opposite corner as shown in the picture.




Step 6 : Repeat step 5 to sew the other two corners together. A small flower has been done!!


 







No comments:

Related Posts Plugin for WordPress, Blogger...